Full Product Manual

HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot be-
fore using the hand-held remote
control unit. See
Lighting Instruct-
ions on page 15.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posit-
ion. Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPO RTANT
: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 14- Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Hand-Held Remote Operation
Selector Switch Position (Optional Remote Control)
Transmission
light
COMMUNICATION BETWEEN THE
REMOTE CONTROL AND THE RECEIVER
To program the transmitter to the receiver, move
the REMOTE position and depress the ON/OFF
key of the transmitter. The System has an auto-
matic learning mode that allows the receiver to
mate with a new transmitter in the event that
the transmitter must be replaced. As soon as
the receiver detects the first correct command
from any compatable remote control it captures
the new address and then "beeps" 3 times to con-
firm the synchronization (programming).
Side
Slide Switch
ON/OFF
Key
Note:
BACKUP FUNCTION
If the batteries in the transmitter (Hand Set) or rec-
eiver are low, the appliance can be switched on man-
ually by moving the 3 position slide switch (see Fig-
ure 14) to the ON position.
Replace or remove low batteries as soon as possible
to prevent corrosion damage to remote control acces-
sory
HAND HELD TRANSMITTER OPERATION
Move the side Slide Switch into the ON position. (tow-
ards the flat end of the unit).Press and release the ON/
OFF Key (see Figure 15) on the Hand Held Remote.
The burner will turn on. Press and release the control
button again. The burner will turn off.
Figure 15 - ON/OFF Hand Remote Control Unit
WIRING DIAGRAM
NOTE:
For proper operation of optional accessories,
the wires from the thermopile to the control valve must
be connected exactly as shown.
Thermopile
IMPORTANT!
After any alteration or adjustment to the Gas Log Set,
make sure the logs are in the correct locations. Make
sure the logs are clear of the main burner flames. Flame
touching the logs may produce sooting!
the REMOTE position (see Figure 14 ).
Make sure
switch is turned
to “OFF” when
lighting; and
“REMOTE” to
use the remote.
18
Figure 16 - Wiring Diagram
the three positions slide switch of the receiver in