Full Product Manual

CONNECTING THE RECEIVER TO THE VA LVE KIT

Attach the connector on the red wire from the valve to the red wire on the receiver.

•

Install the (4) AA batteries in to the receiver.•

After receiver is connected to the valve, make sure the plastic receiver shield (Included) is located over the

receiver, then locate the receiver in an area that will not exceed the 130°F.

•

Receiver Back

Connecto

Connector

LEARNING TRANSMITTER TO RECEIVER

This transmitter has one of 256 unique security codes. It may be necessary to program the remote receiver

to learn the security code of the transmitter upon initial use, if batteries are replaced, or if using a replacement

NOTE:

This receiver can hold up to 3 transmitter codes. This is for the times when a second hand held trans-

mitter is required.

Make sure the receiver’s slide switch is in the

•

REMOTE

position.

Press and release the •

LEARN button on the receiver.

When you hear the “Beep”, press and hold the

•

ON or OFF

button for about 2 seconds on the transmitter.

You will then hear a series of beeps that indicate that your new transmitter has been accepted by the receiver.

•

If you press the

•

LEARN button on the receiver and you hear no beeps, the receiver is unable to retain any

more transmitter codes (make sure that the transmitter and the receiver batteries are properly installed and

To delete all of the transmitter codes on your receiver, press and hold the

•

LEARN

button for 10 seconds.

Then you will hear a series of beeps, indicating that the receiver’s memory has been cleared.

transmitter.

fully charged).

Red Wire

Attach the connector on the black wire from the valve to the black wire on the receiver.