Full Product Manual

BATTERY INSTALLATION AND OPERATION INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO
This remote control system was developed to provide safe, reliable, user-friendly remote control system for
gas heating decorative appliances.
The system can be operated manually from the transmitter.
ON
WALL CLIP
SLOT
12V
BATTERY
COMPARTMENT
FRONT BACK
SIGNAL
LIGHT
ON
BUTTON
OFF
BUTTON
The transmitter operates on a 12V (A23) battery that is included. Install
the 12V battery
supplied with the unit into the battery compartment. It is
recommended that ALKALINE batteries always be used for this product.
Be sure the batteries are installed with the (+) and (-) ends facing
the correct direction.
The LED signal light should illuminate when either the
ON or OFF
button is pressed. If the signal light does not illuminate, check the
position of the transmitter’s battery, and verify the battery is fully
charged.
TRANSMITTER
ON
1
2
KEY SETTINGS
ON -1.
This turns the appliance on.
OFF -2.
This turns the appliance off.
IMPORTANT:
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT
TEMPERATURES DO NOT EXCEED 130º F.
RECEIVER
Install the (4) AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be
used for this product. Do not mix ALKALINE and GENERAL PURPOSE batteries.
Be sure the batteries are installed with the (+) and (-) ends facing
the correct direction.
REMOTE
LEARN
ADJ.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole
Remote Receiver
Battery cover slide
s on/off
Slide
Switch
OFF/REMOTE
OFF
The remote receiver has a 3-position slide switch for selecting the
mode of operation,
which is
OFF/REMOTE/ON
REMOTE
•
: The receiver must be in this position if you want to use
The transmitter may be used to turn the appliance on and off.
respond to the transmitter on initial use, check the
battery positions in the remote. If that does not work, see the
OFF
•
: will disable the remote receiver.
It is suggested that the slide switch be placed in the OFF pos-
ition if you will be away from your home for an extended period
of time to preserve battery life.
the appliance,
LEARNING TRANSMITTER TO RECEIVER section.
OFF
OFF
ON
•
: will allow the appliance burners to operate. .
NOT ATTEMPT TO INSTALL OR OPERATE - CALL CUSTOMER SERVICE [phone]
5