Installation Guide

CONNECTING TO GAS SUPPLY
WARNING: A r rson
must log to gas supply. Follow
WARNING: N natural gas
log to priv (non-utility) gas .
This gas is commonly known as
gas.
CAUTION: N conn t pr
log ctly to t propan LP supply.
This i an rnal gula-
tor (not suppli . Install th t al u-
lator b n t an propan
LP supply.
Figure 4 - External Regulator with Vent Pointing
Down
Pr
Supply Tank
rnal
V
Pointing
Down
WARNING: This applianc i a
” UNF National
NPT (National
gas
pro
INSTALLATION
CONTINUED
IMPORTANT: For natural gas, check gas line pressure
before connecting heater to gas line. Gas line pressure must
be no greater than 10.5” of water. If gas line pressure is
higher, heater regulator damage could occur.
For propane/LP gas, the installer must supply an external
regulator. The external regulator will reduce incoming gas
pressure. You must reduce incoming gas pressure to between
11” and 14” of water. If you do not reduce incoming gas
pressure, heater regulator damage could occur. Install the
external regulator with the vent pointing down as shown in
Figure 4. Pointing the vent down protects it from freezing
rain or sleet.
INSTALLATION CLEARANCES
WARNING: Maintain t minimum c ar-
.
If placing mantel above heater, you must meet the mini-
mum clearance between the mantel shelf and the top of
Figure 3 - Minimum Mantel Clearances for
Installation
NOTICE: Su mp ratur s o a nt
walls man ls b hot uring
. Walls abo
o may hot to touch.
install pro ly, th t p u m t
national pr
r . Follow all minimum c
shown in this manual.