Installation Guide

17
INSPECTING BURNERS
BURNER FLAME PATTERN
Figure 17 shows correct burner Figures 24
18 show incorrect burner The incorrect burner
shows
The
Note:  When using the appliance for the time, the
will be orange
for
approximately
one hour
until the logs cure.
If burner fl e
p ttern is
incorrect
s shown in

Figure 18:


(see To Turn Off Gas
To
Log Set,
 See
Troubleshooting,
not the case, the heater could produce in-
NOTICE: Do not mistake orange flames for
yellow tipping. Dirt or other particles
enter the heater and burn,
causing
brief
p a t c h e s o
f o r a n
g
e.
Figure 18 - Incorrect Burner Flame Pattern
Figure 17 - Correct Burner Flame Pattern
CONTINUED
WARNING: This log set is designed to
operate with flames that have yellow tips,
but are transparent blue overall. If this is
creased levels of carbon monoxide.
If you feel the flames are excessively yell-
ow, have a qualified service person verify
the operation of the unit.
Cleaning And Maintaince
on
CLEANING AND

MAINTENANCE
WARNING: Turn off appliance and let
cool before cleaning.
 CAUTION: Keep burner and control
compartment clean. See installation and
operating instructions accompanying
heater. Inspect these areas of 
before each use. Have inspected
yearly by a service person. Fire-
place may need more frequent cleaning due
to excessive lint from carpeting, bedding
material, pet hair, etc.
WARNING: Failure to keep the primary
air opening of the burner clean may result
in sooting and property damage.
BURNER INJECTOR HOLDER AND
PILOT AIR INLET OPENINGS
The inlet holes the proper of to
with the This burning Keep
these holes of pet
holes will We the
unit three
We lso reco en th t ou eep the burner tube n pilot
sse bl cle n n free of ust n irt To cle n these
p rts we reco en using co presse ir no gre ter th n
30 PSI Your loc l co puter store h r w re store or ho e
center c rr co presse ir in c n You c n use
cuu cle ner in the blow position If using co presse
ir in c n ple se follow the irections on the c n If ou
on't follow irections on the c n ou coul ge the
pilot sse bl
Shut off the the Allow the unit to
Inspect burner pilot n pri r r inlet holes on injector
Chec the injector hol er loc te t the en of the burner
tube g in Re o e n l rge p rticles of ust irt lint or
pet h ir with soft cloth or cuu cle ner nozzle
Blow ir into the pri r ir holes on the injector
In of now been