Installation Guide

13
OPERATING HEATER
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow
A. This appliance has a pilot which must be
lighted by hand. When gnithgil the pilot,
follow these instructions exactly.
B. BEFO RE LIGHTING smell all around the
appliance a rea for gas
. Be
sure to smell nex t
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call you r gas supplier from
a neig hb o r’s pho n e. F o llow the gas
supplie r’s instructions.
• If you cannot re a ch you r gas supplie r, call
the fire department.
C.
Use only your hand to push in or turn the
ga s control knob. Ne ver use tools . If the
knob will not push in or turn by hand, don’t
try to repair it, call
a qualified
service techn-
ician or sag supplier. Force or attempted
repair may result in a fire o r explosion.
D. Do not use this appliance
if any part
has
been under wat e r. Immediat el y call
a
qualified service technician to inspect the
appliance and to replace any part of th
e
control system and any gas cont rol which
has been under water
LIGHTING
INSTRUCTIONS
WARNING:
• If
operate this heater with glass doors
closed. If you operate heater with
doors closed, heat buildup inside
fireplace will cause glass to burst.
Make sure there are no obstructions
across openings of fireplace.
•
You must operate this heater with
sure fireplace screen is closed
before running heater.
NOTICE: During initial operationof new
heater, burning logs will give off a
paper-burning smell. Orange flame will
also be present. Open damper or win-
dow to vent smell. This will only last a
few hours.
Note:
heater with the chimney damper closed. This will
put all the heat intothe room. However, there may be
can open the chimney damper (if you have one) fully
or partially to release some of the heat.
WARNING:
Damper handle will be hot
these instructions exactly, a fire or
explosion may result causing prop-
erty damage, personal injury or loss
of life.
Homeowners generally prefer to operate their
times you will desire the full flames of the HI heat
settings but will find the heat output excessive. You
REMOTE CONTROL MODELS
1. STOP! Read the safety information from this page
column 1.
2.
Make sure equipment shutoff valve is fully open..
3.
Set selector switch in the OFF position.
WARNING: Burners will come on
automatically within one minute after
the pilot is lit, when the selector switch
is in the on position
if heater has been running.
fireplace has glass doors, never
a fireplace screen in place. Make