Installation Guide

ON
POSITION
OFF
POSITION
GRH/OV 020MANUAL SHUT-OFF VALVE
Figure 6 - Equipment Shutoff Valve
Open
Closed
Equipment
Shutoff
Valve
PRESSURE TESTING APPLIANCE
GAS CONNECTIONS
1. Open equipment shutoff valve (see Figure 14).
2. For natural gas, open main gas valve located on or near
gas meter. For propane gas, open propane gas supply
tank valve.
3. Make sure control knob of fireplace is in the OFF posi-
tion.
4. Check all joints from equipment shutoff valve to gas
control valve. Apply noncorrosive leak detection fluid
to all joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light fireplace (see Operating Log Set, page 13). Check
all other internal joints for leaks.
7. Turn off fireplace (see To Turn Off Gas To Log Set, page
14).
INSTALLATION
Test Pressures Equal To or Less Than 1/2
PSIG (3.5 kPa)
1. Close equipment shutoff valve (see Figure 6).
2. Pressurize supply piping system by either opening
propane gas supply tank valve for propane gas or op-
ening main gas valve located on or near gas meter of
natural gas, or by using compressed air.
3. Check all joints from gas meter to equipment shutoff
valve for natural gas or propane supply to equipment
shutoff valve for propane gas.
Apply noncorrosive leak
detection fluid to all joints. Bubbles forming show a
leak.
4. Correct all leaks at once.
CONTINUED
10
REMOTE CONTROL SET
INSTALLATION AND OPERATION
- + - +
COMMUNICATION BETWEEN THE
REMOTE CONTROL TRANSMITTER
AND THE RECEIVER
To program the transmitter to the receiver, move
the three positions slider of the receiver in the
REMOTE position and depress the ON/OFF key
of the transmitter. The System has an automatic
learning mode that allows the receiver to mate
with a new trans -mitter in the event the trans
mitter must be replaced. As soon as the receiver
module receives the firstcorrectcommand from
any remote control it captures the new address
and then "beeps"3 times to confirm the syncron-
ization and command execution.
Remote control set included with log set.
Install four
(4) "AA"
batteries into the
remote receiver box
as shown on the left.
Install three
(3) "AAA"
batteries into the
remotecontrol
as shown on the left.