Installation Guide

INSTALLATION
Continued
5. Turn pressure selecting screw over and reinstall it
in regulator cap (see Figure 10-11).This will adjust
the pressure setting to the LP/Propane gas position.
Make sure the pressure selecting screw is installed
tightly into the regulator cap.
6. Replace the regulator cap on the appliance regulator.
Figure 9 - Gas Selection Valve Knob and
Regulator Cap
Regulator
Cap
Pressure
Selecting
Screw
Appliance
Regulator
Figure 10 - Removing Regulator Cap from Pressure
Selecting Screw
Figure 11 - Turning Pressure Selecting Screw Over/
Attaching to Regulator Cap – LP/Propane
Gas Position
1. Generously apply soapy solution to all connect-
ions.
WARNING: Never check for gas
leaks with open flame.
2. Light the pilot, and burner with the gas shutoff no
more than half open (see
Lighting Instructions,
3. Inspect all connections for bubbles, raw gas odor,
or flame from any area other than the burner (leaks).
If leaks are detected, shut off gas valve immediately.
tighten, or reassemble loose connections (using pipe
joint compound) until burner system is leak free.
Testing Burner for Leaks
4. When burner is tested and Leak free. Observe
individual tongues of flame on burner (from ports).
Note: Make sure that all ports are clear and pro-
ducing flame evenly across burner. If any ports ap-
pear blocked, clear them by removing burner man-
ifold and clearing ports with a modified paper clip or
other suitable tool. When finished testing, turn gas
shutoff valve to OFF to extinguish all flames.
1. Open bag of burner media material (Heavier
rock f
or NG, Lighter vermiculite if set for LP/
Propane) and spread it evenly across burner
pan to the top. You may overflow front and
sides of pan to cover entire pan. Do not cover
valve.
2. Open glowing embers and evenly cover burner
media material (or vermiculite) in burner pan.
Adding Burner Media Material
Installing Grate and Logs
Slide two rear log grate steps over two outer
horizontal supports on t he grate as shown
in image 2 on Page 9.
Install logs onto the grate by following the Log
Placement instructions on the following pages.
1.
2.
8
Page 19). Apply soapy solution to gas connections.
Log Placement
Identify and locate your specific log set on the fol-
lowing pages. Install the logs onto the grate, with
the rear logs pushed to the back of the grate, and
the front log pulled as far forward as it will go.
assemble the top logs as shown.