User's Manual

Page | 39 of 64 User Manual – PariRange – Revision 21019

Tag Activation and Distribution

Once a Tag has been assigned to a User in the PariRange User Interface application, the Tag is

ready to be activated, charged, and distributed to that user. Tags are shipped from EmbedTek

in Sleep Mode. Activate a Tag by placing it on a charger. Once fully charged, distribute the Tag

to the User that it is assigned.

PariRange Contact Tracing Tag Operation

Tag Status Indicators

The PariRange Contact Tracing Tag uses the following signals to communicate its status:

The GREEN LED:

• Active - The green LED will flash every five seconds when actively seeking other Tags

and no other Tags are detected.

• Charging - The green LED will slowly pulse to indicate that the Tag has been

successfully placed on a charger and is charging.

• Fully Charged - The green LED will remain on when the Tag is fully charged.

The RED LED:

• Alert - The red LED will remain on when another Tag is detected within the alert range.

• Low Battery – The red LED will flash every five seconds instead of the green LED when

Active and the battery is low.

• Vibration

o Alert - The Tag will vibrate when another Tag is first detected within the alert

range.

o Charging – The Tag will vibrate when the Tag is successfully placed on a charger

and begins charging.

• The green and red LEDs will turn on simultaneously when the Tag is communicating

with an Access Point.