User`s guide

LPC3250 Developer’s Kit - User’s Guide
Page 33
Copyright 2011 © Embedded Artists AB
The new COM port (USB Serial Port) will be listed under the Ports list. Right-click on the new USB
Serial Port and select Properties, as illustrated in Figure 11 below.
Figure 11 – Device Manager Port Dialog
Select 115200 bits per second, 8 data bits, none parity, 1 stop bit, and none flow control, as illustrated
in Figure 12 below. Then select Advanced settings. Please note that different application programs can
use different baud rate settings for the serial channel. Other baud rates can also be used, depending
on your specific application.
Also note that it is normally not needed to set the used baud rate at all. The driver and FT232R chip
will automatically handle different baud rates. The setting is only shown here for completeness.
Figure 12 – USB Serial Port Properties Dialog
UART settings
Advanced
settings
USB Serial Port
Properties