Hardware manual

phyCORE-LPC3250 QuickStart Instructions

If the data transfer was successful, a screen similar to the Disassembly window below will appear..

The Debug Toolbar is also displayed. In the lower part of the debug screen you will see the Debug

Log window.

You may need to open, resize and /or move some windows to make your screen look similar to the

following screen capture. You can open inactive windows by choosing the desired window from the

View pull-down menu.

7. Execute the code by selecting the Go button from the debug toolbar .

Successful execution of the program will alternately flash LED1 and LED2 (D15 and D18) on the

phyCORE



Carrier Board.

8. Switch to the HyperTerminal window.

9. Press the BTN1 button on the phyCORE



Carrier Board and notice the blinking speed has

changed and BTN1 button is pressed is displayed in the HyperTerminal window.

10. Press the BTN2 button on the phyCORE



Carrier Board and notice the blinking pattern has

changed and BTN2 button is pressed is displayed in the HyperTerminal window.