Product data

Processor
■ Single Pentium
®
M Processor 760 at 2GHz
■ Single Pentium
®
M LV Processor 738 at 1.4GHz
■ Single Pentium
®
M ULV Processor 373 at 1GHz
■ Passive heatsink
Chipset
■ Intel E7320/7520 and ICH6300
■ Front Side Bus: 400/533/800MHz
■ I/O bandwith
■■ Up to 3 x 8 PCI Express lanes
■■ 32-bit/66MHz PCI bus
■■ 32-bit/33MHz PCI bus
■ High-end memory controller
■■ One registered memory DDR channel
operating in lock-step DDR2-400
■■ Support of Intel
®
x4 Single Device Data
Correction (x4 SDDC)
■■ Support of standard SEC-DED (72, 64) ECC
■■ Support of automatic read retry on
uncorrectable errors
■■ Hardware periodic memory scrubbing,
including demand scrub support
■■ 3.2 GB/s bandwidth
Memory
■ 1 to 4GB ECC DDR2 400 memory
■■ SO-DIMM
■■ Prepared for 8GB (as soon as chips are avail.)
■ 4MB nonvolatile SRAM, linear addressing
■ 2MB BIOS/FPGA NOR Flash
■ Up to 1GB NAND Flash (depending on
chip availability)
CompactPCI Bus Interface
■ System-slot or stand-alone operation
■ 32-bit/66MHz 3.3V VIO
PCI Express
■ 2 x 4 lanes to connect local Gigabit Ethernet
controllers
■ 2 x 8 lanes for extension such as high-end
graphics (7520 only)
I/O
■ ICH6300
■■ COM1, COM2 available with SA-Adapter
at the front or on rear I/O
■■ Parallel ATA available on board for on-board
hard disk extension or rear I/O
■■ USB 1.1/2.0: 1 channel at front, 2 via rear I/O
■■ Supports legacy keyboard/mouse SW
with USB devices
■■ Real-time clock with 256B GoldCap backup
CMOS RAM
■■ AC'97 via rear I/O
■ FPGA
■■ 2D graphics controller (VGA upto XGA)
■■ VGA connector at front, LVDS at rear
■■ SRAM controller
■■
NAND Flash controller for on-board Flash disk
■■ Open for additional functions such as HDLC
controllers, CAN etc.
Front I/O
■ VGA or serial lines via SA-Adapter
■ USB
■ 2 Ethernet channels
■ Network
■■ Two 1Gigabit Ethernet channels at the rear
■■ Four 1Gigabit Ethernet channels at the front
■■ Ethernet controllers are connected by 8 PCIE
lanes to guarantee real throughput
BIOS
■ Industrial AWARD BIOS in NOR Flash
with recovery code
■ Save set-ups in Flash option
■ Boot from LAN and from USB capability
■ Extended set-up
■ Disk-less, keyboard-less and video-less
operation is supported
■ System, video and LAN BIOS shadowing
■ Advanced Configuration and Power Interface
(ACPI)
■ Intelligent System Monitoring
(thermal management)
■ Set-up console redirection to serial port
Supervisor
■ Support of a system management interface
via non-intelligent IPMI
■ Flexible Watchdog timers based on FPGA
■ Detection of restart cause from memory
Compliance
■ CompactPCI Core Specification
PICMG 2.0 R3.0
Mechanical Specifications
■ 6U, 4HP standard cPCI 6U board
Power Requirements
(Pentium
®
M 1.4GHz, 1GB memory)
■ +5V (+5%, -3%), 5A typ.
■ +3.3V (+5%, -3%), 2A typ.
Environmental Specifications
■ Temperature range (operation):
■■ 0..+50°C
■■ Airflow: min. 10m
3
/h
■■ Temperature range (storage): -40..+85°C
■ Relative humidity (operation): max. 95% nc
■ Relative humidity (storage): max. 95% nc
■ Altitude: -300m to + 3,000m
■ Shock: 15g/11ms
■ Bump: 10g/16ms
■ Vibration (sinusoidal): 2g/10..150Hz
Operating System Compatibility
■ Windows XP, Windows XP Embedded,
Windows Server
■ Linux
■ VxWorks
7
CompactPCI
MEN CompactPCI
■ Pentium
®
M up to 2GHz
■ 1-slot CompactPCI 32-bit/66MHz
■ System slot or stand-alone
■ Up to 4GB ECC DRAM
■ NAND Flash, SRAM
■ Graphics via FPGA (VGA front, LVDS rear)
■ Up to 4 Gigabit Ethernet
■ Parallel ATA for on-board hard disk
■ PC connectivity as available in chipset
■ Further I/O individually via FPGA
Product available Q IV / 2005
F10 – 3U CompactPCI/PXI Pentium
®
M SBC