Product data

PowerPC MPC8245/400MHz
1-slot 64-bit VMEbus master and slave
512MB DRAM, CompactFlash
Graphics via PMC
Dual 10/100Mbit Fast Ethernet
4 COMs, USB, IDE, keyboard/mouse
2 PMC slots
MENMON BIOS for PowerPC cards
CPU
PowerPC MPC8245, 400MHz
Memory
Level 1 Cache integrated in MPC8245
SO-DIMM slot for up to 512MB SDRAM
133MHz memory bus operation
Boot Flash 2MB or 4MB
8-bit data bus
Optional 32MB application Flash
64-bit data bus
Serial EEPROM 4kbits for factory settings
CompactFlash (TM) card interface for Flash
ATA (true IDE) via on-board IDE
Interfaces
Two 10/100Mbits/s Ethernet channels
82551ER controller
RJ45 at front panel with two LEDs
One UART RS232 serial interface (COM1)
16-byte send/receive buffer
RJ45 at front panel
One UART (COM2)
16-byte send/receive buffer
Physical interface at front panel or using
SA-Adapter via 10-pin ribbon cable on I/O
connector, depending on board version
RS232..RS485, isolated or not: for free use
in system (e. g. cable to front)
Two MPC8245 UARTs
Accessible via I/O connector
IDE port for hard disk drives
Drive can be connected via ribbon cable or
mounted directly on the CPU board using
MEN's adapter kit
Only one VMEbus slot needed even
with hard disk
Keyboard/mouse
PS/2 compatible
External adapters for line drivers required
USB port
External line drivers
Local PCI Bus
PCI Spec. 2.2 compliant
32-bit data bus, 33MHz, 3.3V
VMEbus
Compliant with VME64 Specification
Slot-1 function with autodetection
Master D08(EO):D16:D32:D64:A16:A24:A32:
ADO:BLT:RMW; transfer rate max. 25MB/s
Slave D08(EO):D16:D32:D64:A16:A24:A32:
BLT:RMW; transfer rate max. 25MB/s
1MB dual-ported fast SRAM
Interrupter D08(O):I(7-1):ROAK
Interrupt handler D08(O):IH(7-1)
Single level 3 fair requester
Single level 3 arbiter
Bus timer
Location Monitor
DMA
Mailbox
Mezzanine Extensions
A15a: three PC-MIPs Type I/II on local PCI bus
Compliant with PC-MIP specification
A15b: three M-Modules
Compliant with M-Module standard
Characteristics: D16, D32, A08, A24, INTA,
INTC
A15c: two PMCs
Compliant with PMC standard IEEE P1386
Rear I/O for mezzanine I/O on P2
Miscellaneous
Serial real-time clock with integrated
56-byte NVRAM
Serial hardware watchdog in supervisory circuit
Temperature sensor
Hex switch for user settings
User LEDs (integrated into COM1 connector)
Reset button in ejector handle
Abort button via I/O connector
JTAG/BDM connector
Electrical Specifications
Supply voltage/power consumption:
+5V (4.85V..5.25V), 1.3A typ.
±12V for mezzanines only, tbd.
MTBF: 63,000h @ 50°C
Environmental Specifications
Temperature range (operation):
0..+60°C or -40..+85°C
Airflow: min. 10m
3
/h
Temperature range (storage): -40..+85°C
Relative humidity (operation): max. 95% nc
Relative humidity (storage): max. 95% nc
Altitude: -300m to + 3,000m
Shock: 15g/11ms
Bump: 10g/16ms
Vibration (sinusoidal): 2g/10..150Hz
Software Support
MENMON, Linux, VxWorks, OS-9, QNX
35
VMEbus
MEN VMEbus
A15c – 6U VME64 PowerPC SBC with PMCs