Datasheet

Embedded Artists AB
Södra Promenaden 51
SE-211 38 Malmö
Sweden
Phone/Fax: [phone]
E-mail: [e-mail]
http://www.embeddedartists.com
© Copyright 2010 Embedded Artists AB. All rights reserved. All other products or service names mentioned herein are
trademarks of their respective holders and should be treated as such.
Privacy policy: http://www.embeddedartists.com/privacy.php
Legal: http://www.embeddedartists.com/legal.php
Product Note
EA-OEM-011 & EA-OEM-511
The Art of Embedded Systems Development – made Easy™
3. If solution 2) does not work and result in unreliable operation, the solution is to cut the
CLK2_OUT signal before it reaches SODIMM pad/pin 115. The pictures below illustrate
the operation that is needed. It is a simple cut of one track on the LPC4357 OEM board.
If you have any questions, please contact
us at: [e-mail]
Kind Regards,
Embedded Artists AB
June 4, 2013
Locate track to cut
Track that has been cut.
Do not “dig” into the pcb
material. Just cut the
track on the surface.