User Manual

www.emaxmodel.com

SKYLINE32

3. ESC Calibration

Please make sure to REMOVE PROPELLERS before perform ESC Calibration！

（1）Please select "Configuration", change Maximum Throttle to 2000 and save

（2）Please select "Motor Testing"

①Please check the box for Motor Test

②Move the “Master” slider to MAXIMUM

Apply power to your ship so that all ESC’s are powered. When your ESC’s play their intital tune, move throttle

“Master” quickly to the bottom. You will then hear a confirmation tune. When the tune ends the ESC calibration is

completed. If an ESC continues to beep, unplug the power and start over.

4. Mode Selections

Please select "Mode Selection"

①Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, HEADADJ, BEEPER, OSD SW, etc... Some modes will not appear

unless sensor is connected. Ex: If barometer is not connected to the flight controller, the altitude

mode will not display in the list.

②AUX Channel Select for Modes.

AUX Channel for Modes: Select desired AUX channel for mode, then check the box and save the setting

by click the "SAVE" at right bottom corner. When the mode is selected and the switch is activated

selected mode name will highlight green. Non selected modes will highlight red on the screen.

Some modes need to be selected at the same time to function correctly.