User Manual

www.emaxmodel.com
SKYLINE32
8
channels, flight Modes Options screen will be highlighted green. Other will highlighted red on the
screen. Red LED also indicates whether the it is active or not(red light means that the selected flight
mode is not active). Some models will be based on hardware sensors access situation to decide whether
to display. For example, with hardware without a barometer module ,Altitude hold will not be available.
Some modes need to be selected at the same time to function correctly.
Baseflight-Configurator Introduction
1. Flight Controller and Configurator
（1）Connect flight controller to computer with Micro USB cable，When blue indicator of FC is on,FC start to test it
self simultaneously.
Self test as bellows：
Red green led flashes fast→red led flashes fast→green led off→red led off,green led then flashes a
few times then off (if at this time the red light is constantly green after it is off , indicating some kind
of flight mode has been selected and valid)→ self check completed
（2）In Baseflight Configurator App, select COM port and Baud Rate
（3）Click "Connect", flight controller and configurator and connected when the button change to green.
2. Accelerometer and Magnetometer Calibration
Please select "SETUP"
①Calibrate Accelerometer
Calibrate Accelerometer: Place board or frame on leveled surface, then select "Calibrate Accelerometer". Once the
accelerometer calibration is complete, date will be save automatically. Note: Starting or ending accelerometer
calibration will be show in the message display. (Make sure not to move the board or frame during calibration).
②Calibrate Magnetometer
Calibrate Magnetometer: Select "Calibrate Magnetometer", make sure to rotate the board or frame 360 degree in all
axis within 30sec (rotate axis included: Roll axis, pitch axis and yaw axis). Note: Starting or ending magnetometer
calibration will be show in the message display.