User Manual

www.emaxmodel.com

SKYLINE32

②Calibrate Magnetometer

Calibrate Magnetometer: Select "Calibrate Magnetometer", make sure to rotate the board or frame 360 degree in all

axis within 30sec (rotate axis included: Roll axis, pitch axis and yaw axis). Note: Starting or ending magnetometer

calibration will be show in the message display.

3. ESC Calibration

Please make sure to REMOVE PROPELLERS before perform ESC Calibration！

（1）Please select "Configuration", change Maximum Throttle to 2000 and save

（2）Please select "Motor Testing"

①Please check the box for Motor Test

②Move the “Master” slider to MAXIMUM

Apply power to your ship so that all ESC’s are powered. When your ESC’s play their intital tune, move throttle

“Master” quickly to the bottom. You will then hear a confirmation tune. When the tune ends the ESC calibration is

completed. If an ESC continues to beep, unplug the power and start over.

4. Select Mode

Switching interface into Mode selection.

①Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, etc. To add a mode click “Add Range” and then assign

channel. AUX1 is channel 6 and AUX2 is channel 7.

②Channel Select for Modes.

Click “Add Range”button under any mode to add flight mode. Then select a channel in the drop-down

box as channel for that mode.Then check the box and save the setting by click "SAVE" at right bottom

corner. If the corresponding flight mode of selected channel is active. Then when switching to the