User Manual

www.emaxmodel.com

SKYLINE32

2. Install Configuration Software

（1）Please install Google chrome web browser.

（2）Open Google Chrome web browser, go to "Chrome Web Store" and search BaseFlight - Configurator.

（3）Add " BaseFlight - Configurator" App.

Note: Installing Cleanflight Configurator is similar to Baseflight Configurator, we will not discuss it in this manual

Parameter adjustment

Note: Due to share serial port of USB sand OSD, so when flash firmware of SKYline32 + OSD version flight

control ,another case is when update the firmware of OSD and setting its module interface, ( switch OSD to the OFF

position), to avoid any conflict that caused by using FC and OSD,FC and USB meanwhile that couldn’t connected

with computer.

Cleanflight-Configurator Parameter adjustment

1. Parameter adjustment and FC connection

（1）Connect flight controller to computer with Micro USB cable.

（2）In Cleanflight Configurator App, select the COM port that displays when you connect the Skyline 32.

Baud Rate should be 115200

（3）Click "Connect", flight controller and configurator and connected when the button change to green.

2. Acc & Compass calibration

Please select "SETUP"

①Calibrate Accelerometer

Calibrate Accelerometer: Place board or frame on a level surface, then select "Calibrate Accelerometer". Once the

accelerometer calibration is complete, date will be save automatically. Note: Starting or ending accelerometer

calibration will be show in the message display. (Make sure not to move the board or frame during calibration).