User manual

www.emaxmodel.com

SKYLINE32

Calibrate Accelerometer: Place board or frame on leveled surface, then select "Calibrate Accelerometer". Once the

accelerometer calibration is complete, date will be save automatically. Note: Starting or ending accelerometer

calibration will be show in the message display. (Make sure not to move the board or frame during calibration).

②Calibrate Magnetometer

Calibrate Magnetometer: Select "Calibrate Magnetometer", make sure to rotate the board or frame 360 degree in all

axis within 30sec (rotate axis included: Roll axis, pitch axis and yaw axis). Note: Starting or ending magnetometer

calibration will be show in the message display.

3. ESC Calibration

Please make sure to REMOVE PROPELLERS before perform ESC Calibration！

（1）Please select "Configuration", change Maximum Throttle to 2000 and save

（2）Please select "Motor Testing"

①Please check the box for Motor Test

②Move the “Master” slider to MAXIMUM

Apply power to your ship so that all ESC’s are powered. When your ESC’s play their intital tune, move throttle

“Master” quickly to the bottom. You will then hear a confirmation tune. When the tune ends the ESC calibration is

completed. If an ESC continues to beep, unplug the power and start over.

4. Mode Selections

Please select "Mode Selection"

①Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, HEADADJ, BEEPER, OSD SW, etc... Some modes will

not appear unless sensor is connected. Ex: If barometer is not connected to the flight controller, the altitude mode will