User manual

www.emaxmodel.com
SKYLINE32
7
3. ESC Calibration
Please make sure to REMOVE PROPELLERS before perform ESC Calibration！
（1）Please select "Configuration", change Maximum Throttle to 2000 and save
（2）Please select "Motor Testing"
①Please check the box for Motor Test
②Move the “Master” slider to MAXIMUM
Apply power to your ship so that all ESC’s are powered. When your ESC’s play their intital tune, move throttle
“Master” quickly to the bottom. You will then hear a confirmation tune. When the tune ends the ESC calibration is
completed. If an ESC continues to beep, unplug the power and start over.
4. Select Mode
Switching interface into Mode selection.
①Modes: ARM, ANGLE, HORIZON, MAG, HEADFREE, etc. To add a mode click “Add Range” and then assign
channel. AUX1 is channel 6 and AUX2 is channel 7.
②Channel Select for Modes.
Click “Add Range”button under any mode to add flight mode. Then select a channel in the drop-down box as channel
for that mode.Then check the box and save the setting by click "SAVE" at right bottom corner. If the corresponding
flight mode of selected channel is active. Then when switching to the channels, flight Modes Options screen will be
highlighted green. Other will highlighted red on the screen. Red LED also indicates whether the it is active or not(red
light means that the selected flight mode is not active). Some models will be based on hardware sensors access situation
to decide whether to display. For example, with hardware without a barometer module ,Altitude hold will not be
available. Some modes need to be selected at the same time to function correctly.