Instructions

BLHeliSuite MultipleESC mode 14.3.0.2 and later ©4712
Here a mixed scenario is seen. 1 to 4 match the current firmware brand setting, 5 and 6 do not.
“b” marked ESC in a mixed scenario can only be selected in “Single” mode. If a “Read Setup” is initiated
for a “b” marked ESC, the user will be asked for an interface mode change.
The same will happen if the first automatic “Check” finds Atmel instead of SiLabs or vice versa.
(The 4way-interface in SiLabs C2 mode does not provide this kind of automatic detection.)
f: Indication of ESC after failed flash attempt
If ESC are found (will not occur with “SiLabs C2 4way-if”), where a former flash attempt failed, the
following (or similar) dialog is shown:
9