Instructions

BLHeliSuite MultipleESC mode 14.3.0.2 and later ©4712
The first ESC of the current arrangement always will become the “Master”, the other will be “Slaves”, if
they are parameter compatible with the Master.
(BTW: The ESCs must not necessarily be exactly of the same type...).
Reading and wirting parameters in MultipleESC mode
When “Read Setup” is clicked, only the settings of the Master will be read into the workspace.
When “Write Setup” is clicked, the momentary workspace Settings will be written to all ESC which are
shown as active. Active are only the ESC, which are shown as numbers.
Attention:
ESC # – Name is not distributed to the Slave ESC.
Automatic distribution of Motor Direction to the Slave ESC is optional (off by default).
Automatic distribution of PPM Min/Center/Max Throttle to the slave ESC is optional (on by default).
To switch the synchronization of the optional values use menu “Options… Sync….”
Selecting a MultipleESC arrangement or a Single ESC
Use the left Mouse button to select or deselect an ESC into or out of the active arrangement (“Multiple”
mode.
With “Check” as compatible with the Master detected but deselected ESC are shown as gray dots (..).
Here ESC#3 is deselected = not active.
Here ESC#1 is deselected; ESC#2 now becomes the Master
If only one ESC remains active, the title shows “Single ESC#x”.
3