Instructions

BLHeliSuite MultipleESC mode 14.3.0.2 and later ©4712

Atmel dialog.

SiLabs C2 mode dialog (here ESC#1)

The same will happen if the first automatic “Check” finds only unknown or erased ESC.

x: Indication of ESC with locked device memory

If ESC are found (occurs in MultipleESC mode most likely only with “SiLabs C2 4way-if”) , where the

memory is inaccessible because the lock byte is set, the following (or similar) dialog is shown:

Here ESC#4 is shown as “x”.

“x” marked ESC in a mixed scenario can only be selected in “Single” mode. If a “Read Setup” is initiated

for a “x” marked ESC, a flash confirmation dialog will show up.