Instructions

BLHeliSuite MultipleESC mode 14.3.0.2 and later ©4712

Here ESC#3 is shown as “m”. “m” marked ESC in a mixed scenario can only be selected in “Single”

mode.

u: Indication of unknown firmware (non BLHeli, e.g. SimonK or other) or erased ESC

If ESC are found, where the parameter area does not contain valid BLHeli info, the following (or similar)

dialog is shown:

Here ESC#5 is shown as “u”.

“u” marked ESC in a mixed scenario can only be selected in “Single” mode. If a “Read Setup” is initiated

for a “u” marked ESC, a flash confirmation dialog will show up.