Use and Care Manual

11
Operating Instructions
Troubleshooting Chart (continued)
Problem Possible Causes Resolutions
Excessive use
Head valve(s) not seating
properly
Blown cylinder head gasket(s)
Restriction in head, intercooler
or check valve
Low oil
Dirt in intercooler fins or cylinder
fins
Poor ventilation / ambient
temperature too high
Don’t use it so much man!
Clean or replace
Replace gasket(s)
Clear blockage
Add oil. Ensure oil level is at middle of site glass. See
figure 3, pg. 7.
Use only Airbase Industries oil
(PN: APOL03000G1). Use of any
other product will cause product damage and void
the warranty.
Use low pressure air to blow dirt away from compressor
Increase ventilation around operating area. Ensure com-
pressor has adequate clear space from walls and other
possible obstructions. Ambient temperature should not
exceed 110˚ F.
Overheating
Notes