Use and Care Manual

EMAX
9 | P a g e
Electrical Safety
1. Follow all NEC and local codes for electrical wiring. Allow only authorized service personnel or
certified electricians to install electrical components.
2. Put unit on a dedicated circuit and make sure no other electrical equipment is wired into it. Failure to
wire unit on an independent circuit can cause circuit overload and/or imbalance in motor phasing.
Install proper No Fuse Breaker (NFB) according to the chart listed below. You may also reference
NEC and local codes for additional support.
3. Ensure incoming service has adequate ampere rating.
4. Do not used mixed wire sizes when wiring the unit.
5. The unit must be properly grounded. DO NOT connect ground to air or cooling lines.
Wiring the Compressor
All electrical work must be done by a licensed, certified Electrician in
accordance with all applicable local electrical codes. Damage caused by
improper electrical installation may void your warranty.
DANGER: Be sure only trained and authorized personnel install and
maintain this compressor in accordance with all applicable federal,
local, and state codes, standards, and regulations. Follow all NEC
(National Electric Code) standards especially those concerning
equipment grounding conductors.
DANGER: Improperly grounded electrical components are shock
hazards. Make sure all components are properly grounded to prevent
death or serious injury.
WARNING: When wiring units with magnetic starters, DO NOT install
power directly to the pressure switch. This can cause fire and possible
injury/property damage.