Use and Care Manual

EMAX
16 | P a g e
Maintenance Schedule
The table below is a generalized maintenance schedule based on the normal usage of a compressor. Your
specific needs may vary based on operating environment and duty.
Item
Frequency
Comment
Cleanliness
Daily
Keep the compressor and the surrounding area clean. Wipe off
oil, spills, and dirt/dust.
Oil Level
Daily
Check oil level while the unit is OFF. If oil is low add to fill point. If
level is high, drain off oil.
Tank Pressure
Daily
Check unit for air leaks.
Tank
Daily
Drain the tank daily at the end of use. DO NOT attempt to store
air for prolonged periods of time. The electrical cost is minuscule
compared to replace a rusted out or ruptured tank. DO NOT
attempt to repair a damaged tank.
Anchors
Weekly
Ensure anchors are holding the unit securely and are not loose.
Anti-Vibration Pads
Weekly
Check for wear. Verify they are in place and not damaged or
rotted.
Belt
Monthly
Verify belt tension. Replace if excessively loose or damaged.
Environment
Quarterly (four
times per year)
Air temperature should not exceed recommended levels.
Humidity where compressor is stored should not exceed 70%.
Consider relocating compressor if these conditions cannot be
met.
Wiring
Semi Annually
(twice a year)
Have an electrician check connection from power supply and all
subsequent connections on the unit.
Tank
Yearly
Inspect for rust or corrosion. DO NOT attempt to repair a
damaged tank.
Entire Unit
Yearly
Lock unit out and detail clean.
Air Filter(s)*
See
Comments
Air filters should be changed after the first 100-hour break in
period and every 90 days after that. The frequency will increase
in environments with air contaminants such as dust, paint, dirt,
etc.
Oil*
See
Comments
Oil should be changed after the first 100-hour break in period
and every 90 days after that. This will increase in frequency
depending on actual compressor use and hours unit is running.
*Frequency of these changes are a generalization and may be subject to change based on compressor
environment, hours, and application.