MSDS
Table Of Contents
- Section 1. Identification
- Section 2. Hazards identification
- Section 3. Composition/information on ingredients
- Section 4. First aid measures
- Description of necessary first aid measures
- Most important symptoms/effects, acute and delayed Potential acute health effects
- Over-exposure signs/symptoms
- Inhalation Skin contact Ingestion
- Indication of immediate medical attention and special treatment needed, if necessary Notes to physician : Treat symptomatically.
- Section 5. Fire-fighting measures
- Section 6. Accidental release measures
- Section 7. Handling and storage
- Section 8. Exposure controls/personal protection
- Section 9. Physical and chemical properties
- Section 10. Stability and reactivity
- Section 11. Toxicological information
- Information on toxicological effects Acute toxicity
- Carcinogenicity
- Specific target organ toxicity (repeated exposure)
- Aspiration hazard
- Information on the likely routes of exposure
- Inhalation Skin contact Ingestion
- Delayed and immediate effects and also chronic effects from short and long term exposure Short term exposure
- Long term exposure
- Potential chronic health effects
- Section 12. Ecological information
- Section 13. Disposal considerations
- Section 14. Transport information
- Section 15. Regulatory information
- Section 16. Other information
4/10
Date of issue
: 04/15/2016
Synthetic Piston Compressor Oil
OIL004
Environmental precautions : Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Methods and materials for containment and cleaning up
Spill : Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
Section 7. Handling and storage
Precautions for safe handling
Protective measures :
Advice on general :
occupational hygiene
Conditions for safe storage, :
including any
incompatibilities
Put on appropriate personal protective equipment (see Section 8). Do not ingest. Avoid
contact with eyes, skin and clothing. Avoid breathing vapor or mist. Keep in the original
container or an approved alternative made from a compatible material, kept tightly
closed when not in use. Empty containers retain product residue and can be hazardous.
Avoid contact with used product. Do not reuse container.
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
Under conditions which may generate mists, the following exposure limits are recommended:
ACGIH TLV TWA: 5 mg/m³ ; STEL: 10 mg/m³.
United States
None known.