User Manual

P7 COLORTOUCH REMOTE HANDSET
1. The color wheel buttons and brightness function will be
disabled.
2. Touch Z1, Z2 and all button will change the Zone 1, Zone 2 or
Both Zones color one by one.
3. Reset button will turn all the light color to light’s default first
color for RGB color light. (E-Lumen mode)
It is the default control mode after learning.
1. The mode display LED under at the center of color wheel will be flashed in red
color and ready to touch.
2. The ColorTouch remote choose direct color pick up just by touch the color area.
3. The rainbow color key is a toggle key for multiple modes of auto color change.
4. There are three level of brightness for light brightness adjustment by touch the
desired brightness button.
5. Z1, Z2 and ALL are ON/OFF switch to ON/OFF Zone 1, Zone 2 and both Zones.
The Reset key will turn Z1 and Z2 lights back to Cool White. It will take three
seconds to the light up after switch off.
6. Touch any key and wait for a while for light response.
6.2.1 COLORTOUCH MODE
Put the finger on the top of button and touch it gently, then
remote from it. Keep touching the same button will interrupt the
handset operation.
6.2.2 BASIC MODE
6.3 BATTERY REPLACEMENT
Reverse the remote and open the battery compartment by pushing the right
hand side lock inward. The remote use CR2032 battery that life time is around
six months.
The Color Touch Control Box main power switch must be switched
off and wait for three minutes and then switch on again.
The ColorTouch remote handset is designed with auto sleep
mode to save battery power when it is idle for a while. It will
wake up by touch any button and do the operation.
Switch to 50Hz/60Hz, wait 30s to open control box. If not,
wrong color mode.