User Manual

P5 CONTROL BOX PANEL OPERATION
5. CONTROL BOX PANEL OPERATION
1. switch on the main power switch to turn on the power, the standby button led
will light up.
2. press the standby button, ands the system is entered to operation mode.
3. Z1 Button - long press (3 second) to switch ON / OFF Z1 power. And short press
(1 second) to change color for all the pool lights, connected to the Z1 outlet,
the Z1 Button LED is flashing.
4. Z2 Button - long press (3 second) to switch ON / OFF Z2 power. And short press
(1 second) to change color for all the pool lights, connected to the Z2 outlet,
the Z2 Button LED is flashing.
5. ALL Button - Long or short press to change color for all the pool lights,
connected to the Z1 and Z2 outlet, the ALL Button LED is flashing.
4.1 WIRING DIAGRAM
1. Unscrew the screws from the bottom and take out the housing carefully.
2. Remove the waterproof connector nut and put the transformer 110-220Vac
cable through it.
3. Mount the two wires on the connector as figure.
The terminal voltage is 110-220Vac and never mount the light on
it directly! When input terminal voltage is 220Vac, must connect to
220Vac transformer, not 110Vac transformer.
Color Touch Control Box PCB
Zone 2
Power cord
Zone 1
Power cord
AC Mains
Power cord