Owner`s manual

Battery Powered
1. Depress the Power button to turn the Digital Wallet on. (Figure 1) The screen will show a Minds@Work logo, the Digital
Wallet logo and then the Main Menu.
2. To turn off the Digital Wallet depress the Select button while in the Main Menu, and hold down until the units shuts off.
The battery pack will provide up to 100 minutes of use with approximately 500 recharge cycles.
IMPORTANT! Use of any other batteries, battery pack or charging device can cause malfunctions and permanent damage to the
Digital Wallet. For additional battery packs, visit www.mindsatwork.net to locate a local or online reseller.
To recharge the battery pack, connect the Digital Wallet to AC power. Each full recharge takes approximately 3 hours.
NOTE: The battery pack cannot be fully charged when it is cold. Charge the battery pack in a temperate zone between 32˚ and 104˚F
(0˚ and 40˚C). If recharged above 104˚ F (40˚ C), the battery pack could permanently lose its ability to recharge.
To help preserve energy while the Digital Wallet is battery operated, you can customize a preset automatic shut-off timeframe. Please
refer to “Shut-off Delay” in the Customize Menu section.
AC Adapter Powered
1. Connect the Carry Dock to the Digital Wallet.
2. Plug the AC adapter to an outlet and then to the Carry Dock. The unit will automatically turn on. While running the unit on AC
power, the battery pack will concurrently be charged.
3. To turn off the Digital Wallet, disconnect the AC adapter. Depress the Select button while in the Main Menu, and hold down
until the units shuts off.
IMPORTANT! Only use the supplied AC adapter. Use of a non-approved adapter will degrade charge performance and may cause
permanent damage to battery and/or unit.
POWERING THE DIGITAL WALLET Power up either through the AC adapter or battery pack.
10 Powering the Digital Wallet