Installation guide

96 ZENworks 11 Server Installation Guide
C.3 Post Installation Troubleshooting
This section provides solutions to problems you might encounter after installing ZENworks 11 .
 “Unable to access ZENworks Control Center of a ZENworks Server installed on a OES or SLES
device” on page 96
Unable to access ZENworks Control Center of a ZENworks Server
installed on a OES or SLES device
Source: ZENworks 11 ; Installation.
Explanation: During the installation of ZENworks Server on OES or SLES device, if you have
specified the port as 8080, the installation is successful. However, you might not
be able to access the ZENworks Control Center of the ZENworks Server from
any device.
Action: To access the ZENworks Control Center of the ZENworks Server, perform the
following steps on the OES or SLES device on which you have installed the
ZENworks Server:
1 Start YaST.
2 Click Firewall
3 In the Firewall Configuration Window, click Allowed Services.
4 Click Advanced.
5 In the Additional Allowed Ports dialog box, replace http-alt in the TCP Ports
and UDP Ports options with 8080 and complete the Wizard.