Installation guide

Installing the ZENworks Server 49
4 Continue with Section 4.3, “Verifying Installation,” on page 59.
5 Do any of the following that are applicable, then continue with Step 4:
 To create another Primary Server for the Management Zone using the same installation
method that you just used, return to Step 1.
 If you created a response file in order to perform an unattended installation on other
servers, continue with Section 4.2.2, “Performing the Installation,” on page 59.
The information you need is listed in the order of the installation flow.
Table 4-1 Installation Information
Installation
Information
Explanation
Installation path
For Windows, the default is
%ProgramFiles% . You can change it to any path
currently available on the server except to the
%systemdrive%/Program Files
directory if the server is a 64-bit Windows device. However, the installation path that
you specify must contain English characters only.
NOTE: On the Windows server, installation of ZENworks 11 from mapped drive is not
supported.
The installation program creates the
Novell\ZENworks directory here for the
installation of the ZENworks software files.
IMPORTANT: If you want to install Reporting Server on a 64-bit Windows device that
is using an Oracle database, you must specify a customized location to install
ZENworks Configuration Management. This customized location must not include
any parentheses in the pathname because Reporting Server fails to install in a path
that has parentheses.
NOTE: If you want to install ZENworks Reporting Server, ensure that short MS-DOS
(also called 8.3) style naming convention is available for the installation location of the
ZENworks 11 Server. By default, 8.3 is enabled on the device. For more information
on how to enable 8.3 see, Microsoft documentation (http://technet.microsoft.com/en-
us/library/cc959352.aspx)
If you need more disk space for your content repository than is in the Windows path
that is available during installation, you can change the path to another location after
completing the installation. For more information, see .
For Linux, several fixed installation paths are used:
/opt/novell/zenworks/
/etc/opt/novell/zenworks
/var/opt/novell/zenworks
/var/opt/novell/log/zenworks/
If you are concerned about disk space on the Linux server, the /var/opt directory is
where the database and content repository reside. Make sure it is on a partition large
enough for them.