Installation guide

46 ZENworks 11 Server Installation Guide
3.3.5 Installing Mono 2.0.1-1.17 on SLES 11
If your SLES 11 device on which you want to install ZENworks 11 Configuration Management does
not have Mono installed, do the following to install Mono 2.0.1-1.17:
1 Start the ZENworks 11 Configuration Management installation program by using one of the
following methods:.
 Graphical User Interface (GUI) installation: Mount the Novell ZENworks 11 installation
DVD, then run
sh /media/cdrom/setup.sh . Using the sh command resolves rights
issues.
 Command Line installation: Do the following:
1. On the installation server, insert the Novell ZENworks 11 installation DVD.
2. Mount the DVD.
3. To start a command line installation, do the following:
a. To a directory where all (including “others”) have read and execute access, either
mount the DVD or copy the DVD’s files.
This cannot be in
/root or any directory under it.
If you copy the DVD's files, make sure that all (including “others”) continue to have
read and execute access to the destination directories.
b. Run the following command:
sh /mount_location/setup.sh -e
2 Install Mono bundled with ZENworks 11 Configuration Management.
3 (Optional) The ZENworks 11 Configuration Management installation program allows you to
continue to install ZENworks 11 Configuration Management. For more information on how to
install ZENworks, see Section 4.1, “Performing the Installation,” on page 47.