Installation guide

28 ZENworks 11 Server Installation Guide
Review the following scenarios for instructions on how to achieve coexistence of ZDM 7 with Asset
Management or Patch Management in the management zone.
 “Scenario 1: Installing ZENworks 11 Asset Management or ZENworks 11 Patch Management” on
page 28
 “Scenario 2: Installing ZENworks 11 Configuration Management or ZENworks 11 Endpoint
Security Management along with ZENworks 11 Asset Management or ZENworks 11 Patch
Management” on page 28
Scenario 1: Installing ZENworks 11 Asset Management or ZENworks
11 Patch Management
When you install the ZENworks 11 , activate the product license for ZENworks 11 Asset Management
or ZENworks 11 Patch Management. To activate the product license, do the following in the
ZENworks 11 Installation Wizard:
1 In the License Key Panel under Choose the products to be installed, select the Evaluate check
box or specify the license key only for Asset Management and Patch Management.
For more information on how to install the server, see “Performing the Installation” on page 47.
2 Follow the prompts to complete the installation process.
Scenario 2: Installing ZENworks 11 Configuration Management or
ZENworks 11 Endpoint Security Management along with ZENworks
11 Asset Management or ZENworks 11 Patch Management
Use one of the following methods to install ZENworks 11 Configuration Management or ZENworks 11
Endpoint Security Management along with ZENworks 11 Asset Management or ZENworks 11 Patch
Management:
Method 1:
If you have more devices managed exclusively by ZENworks 11 than devices managed by ZDM 7,
you must perform the following tasks to achieve ZENworks 11 and ZDM 7 coexistence:
1 Activate all of the products by providing valid product license keys during the installation of
ZENworks 11 .
For more information on how to activate a product license key, see “Performing the Installation”
on page 47.
2 Before deploying the ZENworks 11 Adaptive Agent, you must configure the ZENworks 11
Configuration Management and ZENworks 11 Endpoint Security Management Agent features
not to be installed:
2a In ZENworks Control Center, click Configuration.
2b In the Management Zone Settings panel, click Device Management, then click ZENworks
Agent.
2c In the Agent Features panel, select the Installed and Enabled option next to the Patch
Management and Asset Management Agent features
2d Deselect the Installed option next to the Configuration Management and Endpoint Security
Management Agent features.
2e Click Apply.