Use and Care Manual

TECHNICAL FILE
R03.001_09/12/2010
You can nd out more information about the technical features of Emac®’s products by downloading
its Technical File in www.emac.es.
If you have any query, please contact our Technical Department in [e-mail].
Technical information
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail] // Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Novoescocia® S
Placement
Cleaning and maintenance
Indoors Wall tiling Flooring Recyclable
Page 3 of 3
The product must be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry it to remove the humidity excess. The persistent dirtiness can
be removed by using cleaning approved agents lightly abrasive or a grid covered with polished powder
neutral. If a preserving agent is applied, as well as keep a very thin layer of water repellent, note that it
can’t be yellow,attract dust or dirt or have iridescent effects.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).
1. Place tiles on the wall that will support the part of the prole without anchoring wing.
2. Spread a big amount of thin-set mortar on the other surface, without tiles, perpendicular to the rst
one.
3. Align the prole with the tiling and then press to make the thin-set mortar passes through the holes
on the anchoring wing.
4. Place tiles along the anchoring wing and press to achieve an optimal adhesion.
5. Finish the tiling, clean the remaining material and let dry.
*In humid environments or in direct touch with water, it is recommended to seal the joints between Novoescocias® with silicone.
In intersections it is recommendable to use the angle pieces designed for that purpose. In the case of
the internal angle, it will be necessary to cut a small section of the anchoring wing to achieve a joint
without overlaps.
To nish off the ends of the prole which are visible, you have covers available in the same nish than
Novoescocia® S.
To achieve a perfect nish and protection, we recommend the installation of Novolistel® 3 in external
vertical edges as a complement for these Novoescocia®. This listello is available with the same nish
than Novoescocia® with control of the microbial deterioration. The complementary angle pieces allow
its combination, guaranteeing a perfect nish in the joints, also with a nish with control of microbial
deterioration.
Outdoors