Specification

R03.001_22/09/2023

TECHNICAL DATA SHEET

Color Touch Collection

Installation

3/4

Walls

Flooring

4 5

1 2 3 4 5

1. Tile one of the sides of the wall to be tiled. Then, spread a big amount of thin-set mortar on the

other side.

2. Place the Novosuelo/Novopared on the corner and press to let the thin-set mortar pass through

the holes of the anchoring wing.Coloque el Novosuelo/Novopared sobre el ángulo y presione para

que el material de agarre pase a través de los agujeros mecanizados del ala de ﬁjación.

3. Place tiles along the anchoring wing and then press them softly to get an optimal adhesion.

4. Continue tiling until the installation is ﬁnished

5. Clean the possible leftover and let dry.

1. Spread a big amount of thin-set mortar on the surface to be tiled.

2. Then, place the proﬁle and press it to let the thin-set mortar pass through the holes on the anchoring

wing.

3. Place a tile on the anchoring wing of the proﬁle and press to get an optimal contact with the thin-

set mortar.

4. Repeat the previous step placing tiles along the proﬁle until the installation is ﬁnished. Before

curing, tap with a rubber hammer to align the proﬁle with the pavement.

5. Finally clean the leftover material and let dry.

Cleaning and maintenance

The product must be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must

rinse the proﬁle with cold water and dry it to remove the humidity excess. The persistent dirtiness can

be removed by using cleaning approved agents lightly abrasive or a grid covered with polished powder

neutral.

Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and

perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.

Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.

Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes

(hydroﬂuoroether and chlorinated solvents) and curing accelerators containing chlorides should not be

used (use special accelerators free of chlorides).