Instructions

Charging station
Cable
Vehicle connector
Vehicle inlet
esptouch for iOS:
https://apps.apple.com/app/espressif-
esptouch/id1071176700
esptouch for Android:
https://play.google.com/store/apps/details?id=com.
dparts.esptouch
https://github.com/EspressifApp/EsptouchForAndroid/
releases/latest
Fig.1 / WiFi conguration
Fig.2 / WiFi conguration successful
1. Remove the type 2 plug from the charging plug holder (CT) and connect it to the vehicle‘s
charging port. Please ensure that the vehicle is prepared and set for charging. If you have
purchased the charging station as a socket variant (ST), rst connect your Type 2 charging
cable to the Type 2 socket of the charging station, and then to the charging port of your
electric vehicle.
2. The charging process starts when a pre-congured RFID card touches the designated area
for RFID application. Also, the charging process can be stopped by touching the area with
the RFID card. 3.
3. After charging is complete, remove the Type 2 plug from the vehicle‘s charging port. Insert
the type 2 plug into the charging plug holder (CT). If you have purchased the charging
station as a socket variant (ST), put the protective cap back on the type 2 charging plug.If
you cannot pull out the plug, press the unlock button of the vehicle or key.
4. Emergency stop button Press this button to stop the charging process immediately.
Communication
The charging station has the following interfaces for communication: Wi-Fi, Ethernet, RS-485.
If the charging station is connected to an Internet connection via the Wi-Fi or Ethernet inter-
face, the charging station can be connected to a backend for the management of charging
stations via OCPP (Open Charge Point Protocol). The charging station can be programmed,
controlled and monitored via RS-485.
WiFi
Attention: An app for operation is not available.
1. Prepare a 2.4 GHz WiFi router and an Android or iPhone smartphone. Make sure that the
charging station and the smartphone are in the same WiFi range.
2. Turn on the Wi-Fi router, make sure that the router can connect to the Internet. 3.
3. Turn on the smartphone‘s WiFi, connect the smartphone to the router via WiFi, and make
sure that the terminal can access the Internet via the router.
4. Install the „esptouch“ APP on your smartphone.
Open the EspTouch app, select „EspTouch“ (not „EspTouch V2“)
from the list and grant the app the location authorization.
Now enter the password for the currently connected WiFi network
and press „Conrm“ or „Start“ to perform the WiFi conguration.
5. Press and rotate to reset the emergency stop button three times in
succession until the four indicator lights illuminate in a cycle
corresponding to the running lamp mode. At the same time, the
LCD screen changes to the WLAN conguration page.
Click the „CONFIRM“ button of the APP on the smartphone (Fig.1).
6. When all the indicator lights ash once in a second, it indicates that the charging station‘s
Wi-Fi conguration is completed. At the same time, the LCD screen will display
„Successful“ and the name and password of the WLAN SSID (Fig.2).
Note: If the conguration fails, please set the „Multicast“ option in the „EspTouch“ app
and repeat the process.
Note: The charging station supports only 2.4GHz wireless networks. Please make sure
that your Wi-Fi network operates in the 2.4GHz band.
Note: The IP address of the charging station is negotiated via DHCP. Manual setting is
not possible.
12
GB