Instructions

ManualsBrandsEM2GO ManualsCar & BicycleeMobility charging station Type 2 16 A 11 kW RFID

Fig.3Fig.2Fig.1

Fig.1 Fig.2

Important Note:

According to §19 NAV of March 21, 2019, the operation of charging devices for electric

vehicles must be reported to the responsible electricity provider before use (from 11 KW)

and before installation (from 22 KW). This can also be done by the commissioned electrician.

Please contact your electricity provider by phone or online for more information.

Package contents:

• EV charging station and CEE cable

• 2 x RFID card (o󰀪ine mode)

• Wall mounting incl. screws and dowels

• Instruction manual

Mounting

The EM2GO EV chargers provide a user-friendly operator interface with the appropriate

communication interfaces.

Warning

A damaged EV charger must not be installed under any circumstances.

In case of damage, please inform your dealer immediately.

The installation and wiring must be carried out by a specialist company.

EM2GO EV chargers are equipped with a three-phase CEE plug and can be plugged into a

suitably installed and secured CEE socket.

Danger of electric shock!

Make sure that the plug of the CEE cable is not connected to the mains when

connecting to the charging station!

Mounting the supply cables:

First, mount the wall bracket using the mounting accessories included in the scope of delivery.

1. Remove the cover (1).

2. Feed the input cable through interface (2).

3. Connect the cable lugs to the screw terminal of the charging station as follows and

screw this tight (approx. 4Nm): L1 Brown | L2 Black | L3 Gray | N Blue | PE Green-yellow

4. Close the cover (1) again.

Wall mounting:

NOTE: Please take into account that the length of the connection cable of the charging

unit is 150 cm (±5%), the three-phase junction box should be located in this area. The

charging unit is equipped with a residual current device (RCD Typ B). Please ensure

that your three-phase socket is equipped with the appropriate fuse switch.

Mounting accessories:

• Wall mount

• Screws for holder

• Dowels

1. Place the wall bracket where you want to place the charging station. Make sure that

the CEE power connection is within a radius of 1.5 meters. Drill 4 mounting holes

with a diameter of 10 mm and a depth of 50 mm at the appropriate height (Fig.1).

2. Insert and countersink the dowels into the drilled holes.

3. Screw the wall mount to the wall with the screws.

4. Place the charging station on the wall bracket with the rear side facing upwards (Fig.2).

5. Fasten the left and right screws to secure the wallbox to the wall bracket (Fig.3).

No liability will be accepted for any damage caused by incorrect operation.

If you need technical support, please contact our support team via our website