Data Sheet

Preliminary
DATASHEET Ɩ EMBP00
Copyright 2019, EM Microelectronic-Marin SA
EMBP00-DS, Version 0.1, 3-Apr-19
7
www.emmicroelectronic.com
SAFETY File
1. Information on all plastics (flame rating and UL listing) model numbers
2. Battery: Specification, UL listing, and reports from vendor (Standards are UL 1642 and IEC/EN
62133)
3. PCB Board (same information as plastics)
6.4.2. Regulatory Information USA
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
 Part 15 – General emissions
 Part 15.247:2011 – Operation within the band 2.4-2.4835GHz
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Permitted Antenna
This radio transmitter model, FCC ID: 2ACQR-EMBP0 has been approved by FCC to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Table 4: FCC Permitted Antenna
Type
Max Gain
Integrated PCB IFA
1.5 dBi
6.4.3. Regulatory Information Canada
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Les changements ou modifications non expressément approuvés par la partie responsable de la conformité
pourraient annuler l'autorisation de l'utilisateur d'utiliser l'équipement.
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two
conditions: (1) This device may not cause interference; and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
 ICES-003 – General emissions
 RSS-210:2010 – Low-power License exempt Radio Communication Devices
Permitted Antenna
This radio transmitter model, IC: 12155A-EMBP0 has been approved by the ISED to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Table 5: IC Permitted Antenna
Type
Max Gain
Integrated PCB IFA
1.5 dBi
Le présent émetteur radio modèle, IC: 12155A-EMBP0 a été approuvé par ISDE pour fonctionner avec
les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non
inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits
pour l'exploitation de l'émetteur.
Table 6: IC Permis Antenne
Type
Max Gain
Integrated PCB IFA
1.5 dBi