System information

52
NUM TIME ACTION SPEED
1 WHO 0 0 0 0 NONE OFF
2 WHO 0 0 0 0 NONE OFF
3 WHO 0 0 0 0 NONE OFF
4 WHO 0 0 0 0 NONE OFF
5 WHO 0 0 0 0 NONE OFF
6 WHO 0 0 0 0 NONE OFF
7 WHO 0 0 0 0 NONE OFF
8 WHO 0 0 0 0 NONE OFF
Figure 3.3.20 Figure 3.3.21
WEEK WHOLE WEEK
START (H-M) 00 00
END (H-M) 00 00
DONE: OPEN
QUIT: CLOSE
Use the joystick or Left and Right buttons to position the cursor beside WEEK, START (H-M) or END (H-M), and then use the
joystick or Up and Down buttons to select the specific day or time. The weekday can be set to be from Monday to Sunday or
Whole Week.
- TASK PREVIEW
Enter the TASK PREVIEW menu to view the time, action and state of the current task defined. Refer to Figure 3.3.21.
- TASK CLEAN
Enter the TASK CLEAN menu to delete the time and action of the current task.
3.3.7 PATTERNS
A pattern is a memorized, repeating series of pan, tilt, zoom, and preset functions that can be recalled with a command from a
controller or automatically by a configured function (alarm, park, time task, or power-up).
Refer to Figure 3.3.22 for the PATTERNS settings menu:
REMAIN MEMORY 100
DONE: OPEN
QUIT: CLOSE
Figure 3.3.22 Figure 3.3.23
PATTERN
PATTERN NUM 1
EDIT PATTERN
PREVIEW
DELE PATTERN
REMAINING 100
BACK EXIT
- PATTERN NUMBER
The number of pattern under current operation. The dome provides 4 patterns numbering from 1 to 4.
- EDIT PATTERN
Enter the EDIT PATTERN menu, as shown in Figure 3.3.23 Operate camera functions to configure the pattern. The REMAIN ME-
MORY indicates the memory available to configure the patterns. When it displays 0, no patterns can be memorized any more.
Note: When configuring and calling the pattern, the auto flip will be valid; and the pan/tilt movement and the lens operation can-
not be memorized simultaneously.
- PREVIEW
Enter the PREVIEW menu to view the current pattern which has been defined.
- DELETE PATTERN
Enter the DELE PATTERN menu to delete the current pattern.
Note: The deletion of the current pattern will cause its following pattern to be deleted as well, e.g., if the pattern 2 is being de-
leted, then pattern 3 and pattern 4 will be deleted as well.
3.3.8 PRIVACYS
The window blanking allows a user to configure the four-sided areas that cannot be viewed by the operator of the dome system.
A blanked area will move with pan and tilt functions and automatically adjust in size as the lens zooms telephoto and wide.
Refer to Figure 3.3.24 for the PRIVACYS settings menu.
- BLANK NUMBER
The number of window blank under current operation. The dome provides user-defined 24 window blanks numbering from 1 to
24, and up to 8 windows can be configured at the same image. Specific number of available window blanks varies depending
on camera model.
GB