System information

ManualsBrandsElvox ManualsHome building and DecorTelecamera speed dome IR Speed Dome

3.1 Main Menu

IN PELCO-P/D or other PTZ protocols, the main menu can be entered by calling preset 95 through DVR, Keyboard or Client Soft-

ware, as shown in Figure 3.1.1. For instance, press the PTZ button on DVR front panel to enter the PTZ control mode, and then

press the REC button followed by numeric 095 to access the main menu; or press the SHOT + numeric 095 and then the Enter

button from the control keyboard to access the main menu.

In PRIVATE-Code protocol, directly press the Menu button on DVR front panel to access the main menu.

Change cursor position through joystick or direction buttons on the front panel of DVR and move the cursor to the selected menu

item. Press IRIS+ to confirm, i.e., operation can be done on this menu options. If current menu contains sub-menu, enter the

corresponding sub-menu.

To perform operation on menu option, the selected number behind menu item can be changed by moving joystick up and down.

Press IRIS+ to confirm and return to previous menu. The same procedure is followed for the next operation for which no de-

scription is given. Select Exit menu option to confirm and exit from menu operation.

MAIN MENU

LANGUAGE ENGLISH

SET TITLE OFF

EXIT

SYS INFO

TYPE DS-2AF1-713

ADDRESS 0

COM FORMAT 2400, 8, 1

PROTOCOL PELCO-D

TEMPERATURE 27

VERSION 2,10

BUILD DATE 10.04.22

BACK EXIT

Figure 3.1.1 Figure 3.2.1

3.2 System Information

This menu displays current dome system information, as shown in Figure 3.2.1. Information in menu option cannot be changed

and Temperature refers to internal temperature of dome.

Move the cursor to Back and click IRIS+ to return to the previous menu, or move the cursor to Exit and click IRIS+ to save the

settings. Operation is similar to all other submenus.

3.3 Dome Settings

Enter the Dome Settings menu, as shown in Figure 3.3.1 and Figure 3.3.2.

Note: use the Left and Right direction buttons to enter the next page and back to the previous page of the menu if available.

DOME SETTINGS

SOFT ADDRESS 1

SOFT ADDR ACTIVE OFF

SOFT BAUD 2400

SOFT BAUD ACTIVE OFF

BROADCAST ADDRESS ON

PELCO CHECKSUM ON

SYS TIME

BACK EXIT

SYS INFO SETTINGS

ZERO ANGLE

DISPLAY SETTINGS

LED PARAMETER

FAN CONTROL TEMP

BACK EXIT

Figure 3.3.1 Figure 3.3.2

3.3.1 INFO SYSTEM SETTINGS (Settings System Information)

The SYS INFO SETTINGS menu is used to display the form template dome (dome drive), the software version, available me-

mory, information relating to the DIP switches and other diagnostic information. Refer to Figures 3.3.3 and 3.3.4.

- SOFT ADDRESS (virtual address)

When the option SOFT ADDRESS (virtual address) is enabled, the speed dome camera using the virtual address, as shown in

Figure 3.3.3, and addresses selectable from 1 to 255. When the option ACTIVE SOFT ADDR is set to OFF (disabled), it uses the

physical address set by DIP switch. When the address of the control device is set to 0, you can also control the speed dome

camera corresponding to any address.