System information

40
GB
- Compass Direction
The dome will show the direction when user manually controls it to rotate. The detailed display information is as below:
Display N NE E SE S SW W NW
Indication North Northeast East Southeast South Southwest West Northwest
The azimuth zero indicates the north direction.
- RS-485 Failure Diagnostics
In the presence of failure at the transmitting and receiving terminals of RS-485 communications, the speed dome is capable of
performing self-test and detecting the fault results which will be displayed on the screen.
- Soft Baud Rate
The baud rate of dome can be configured by the menu without need of DIP switch settings.
Chapter 2 - operation instructions
2.1 Power-up Action
After the power is applied, the speed dome will perform self-test action that begins with lens actions and then pan and tilt mo-
vement. After completion of power-up self-test actions, the interface as shown in Figure 2.1 will be displayed on screen for 120
seconds.
The System Information displayed on the screen includes the Dome Address, Protocol, Version and other information. The COM
FORM refers to the baud rate, data bit and stop bit of the dome, e.g., “2400, 8,1” indicates the dome is configured with the baud
rate of 2400, 8 data bits and 1 stop bit.
TYPE DS-2AF1-713
SN 000272031
ADDRESS 1
COM FORMAT 2400, 8, 1
PROTOCOL SELF ADAPTIVE
VERSION 2,10
BUILD DATE 10.04.22
PAN CHECKING
2.2 Basic Operations
The following operation shall be done with the use of control device or client software. The control devices include control key-
board and DVR, etc. And the client refers to the client application software. Examples are given here for common operation pro-
vided that the current control system supports following operation. Please refer to Client Software User Manual for detail
operation guide.
Pan and tilt movement: move the joystick to the desired direction, or press the Up/Down/Left/Right buttons.
Zoom operation: press ZOOM+/TELE button to make the lens closer and magnify the scene. Press ZOOM-/WIDE button to
make the lens farther and minify the scene.
Focus operation: After FOCUS+/FAR button is pressed, the object far away will become clearer while the object in vicinity will
be ambiguous. After FOCUS-/NEAR button is pressed, the object in vicinity will become clearer while the object far away will
become ambiguous.
In auto focus mode, camera will focus automatically to maintain clear image. This feature can also be achieved by manually as
well. However, after other operation of device, camera will resume auto focus.
Iris operation: press IRIS+/OPEN to enlarge the iris and increase the image brightness. And by pressing IRIS-/CLOSE, the iris
will gradually shrink that decreases image brightness. In auto iris mode, the IRIS+/OPEN and IRIS-/CLOSE buttons are still ope-
rable. However, after finishing other operation by dome, camera will resume auto iris action.
Preset operation: Preset can be programmed or called through keyboard or menu. The dome provides 256 presets. Press the
SHOT button and then the numeric keys to call the programmed preset. E.g., the callup of preset 08 can be achieved by pres-
sing PRESET button and then the numeral 08. Please refer to Section 3.3.4 for the configuration of presets.
Note: the callup of presets, including the presets with special functions, will be restricted by the limit stops if defined. Callup of
presets programmed out of the limit stops will be invalid.
Figure 2.1