Installation manual

6.2 Pendant Mounting Instructions

The pendant mounting is applicable to the indoor/outdoor solid ceiling construction which should comply with the following

mounting requirements:

- The ceiling must be thick enough to mount the expansion screws.

- The ceiling must be capable of supporting up to 8 times the total load of the dome and its accessories.

Step 1: Install the mounting base

Drill four 6 holes in the ceiling according to the fastener holes locations of the mounting base, and then insert M6 expansion

screws (not supplied) into the holes. Pull the power cord, video cable and control line through the opening at the mounting

base. Secure the mounting base to the corner by using nuts and washers to tighten the four expansion screws.

Note: Make sure the cables have enough length. For outdoor applications, please apply water-proof measures between the cei-

ling surface and mounting base and around the cables opening. The pendant mounting application is not recommended for out-

door environment where directly suffers rain.

Applicable to pendant domes with the use of the pendant pole and pole adapter.

- Pendant Pole

- Pendant Adapter