Installation manual

Step 3: Install dome to the mount

Feed the cables through the opening on top of the back box, and attach the dome to the mount. Finally, use M3 screws to se-

cure the two units. Refer to Section 1.2 for installation instructions.

Note: Follow the same instructions described above for the Short-arm Corner Mount installation. For outdoor applications,

please adopt the water-proof measures. The Short-arm Wall Mount is not recommended for outdoor applications.

Step 2: Secure the wall mount to the corner

Apply four hex screws with the spring washers to the corner adapter through the wall mount and gasket.

Note: When tightening the screw, it is better to compress the spring washer firstly and then rotate half a round so as to main-

tain required waterproof effect without damaging the threads.