Installation manual

GB
- Corner Adapter
For use with the wall mount in the corner mounting applications.
- Mounting Accessories
51
I
4.2 Corner Mounting Instructions
The corner mounting is applicable to the indoor/outdoor 90° solid corner construction which should comply with the following
mounting requirements:
- The wall must be thick enough to install the expansion screws.
- The wall must be capable of supporting up to 8 times the total load of the dome and its accessories.
Step1: Install the corner adapter
Drill four holes in the corner according to the mounting locations, and then insert M6 expansion screws (not supplied) into the
holes. Pull the power cord, video cable and control line through the opening of the corner adapter. Secure the corner adapter
to the corner by using nuts and washers to tighten the four expansion screws.
Note: Make sure the cables have enough length. For outdoor applications, please apply the sealant around the cable opening
to prevent water.