User manual

52WS/4

9/12

Chapter 3 Configuration via Web browser

Before visit the camera via web browser, user should adjust security level. Open the web browser, and

enter the menu “Tool/ internet option/Security/Custom level”, then set the security level to Security

Level - Low, or enable ActiveX Control and the Plug-in directly. Figure 3.2.1 gives you a visual illustra-

tion. After you can see the camera video, recover the security level for security.

1, Failure to control PTZ

It is possible that the camera and equipment are not connected through RS485 port, or the wrong con-

figuration of the decoder.

2, Certain individual channel picture is un-normal

Please check whether the video cable is well connected with the camera and the Embedded DVS

3, Possible reasons which can cause the failure of upgrading

Failure of the network, IP address error in the FTP host computer, FTP service is not been booted by

PC, the path to upgrade is incorrect; no permission (usually happened when to upgrade through

client-end.)

If the above information cannot meet your demand, please not hesitate to contact the provider.

Fig. 3.1 Set the Security Level