User manual

81
EN
CCTV
6 Manage DVR
6.1 Check System Information
Check system information includes five submenus: system, event, log, network and online user.
6.1.1 System Information
In this tab, user can check the hardware version, MCU version, kernel version, device ID, etc.
6.1.2 Event Information
In this tab, you can search for events like motion and video loss. The utility provides an interface to have a date based and a
channel based search. This report can further be saved on a USB flash drive as an html file using the export button.
6.1.3 Log Information
In this tab, you can search for relevant logs as per the set date and event which includes operation, setup, playback, backup,
search, check information and error. This report can further be saved on a USB flash drive as an html file using the export button.
6.1.4 Network Information
In this tab, you can check relevant parameters of network.
6.1.5 Online Information
In this tab, you can check the details of the connected online users.
Refresh: refresh the current interface.
Disconnect: Disconnect the online users to access DVR. If this function is used by the admin, the particular PC will not be able
to access the device for five minutes.
6.1.6 Record Information
In this tab, a user can check resolution, ftp and record status including motion based recording, manual recording or schedule
recording.
6.2 Disk Management
1. Format the disk
Step1: Enter into disk management tab.
Note: please format the hard disk before recording. If not formatted, it will show the status of the disk-free space, and total
space at the bottom of screen.
Step2: Click Refresh button to refresh the disk information in the list box;
Step3: Select a hard disk and click Format button to start format.
Note: All recorded files in the hard disk will be lost once it is formatted.
2. Advanced
User may check model, S/N, firmware, health status of the disk in this interface. User also can monitor the temperature, internal
circuit, dielectric material of the disk, analysis the potential problems of the disk and warn so as to protect its data.
6.3 Upgrade
The DVR can be upgraded by using USB flash drive. Get the upgrading software from your vendor when there is a new
software version.
Upgrade Steps:
Step 1: Copy the upgrade software which gets from vendor into the USB storage device
Step 2: Connect the USB flash drive to the USB port.
Step 3: Enter MenuÆUpgrade tab. Then the upgrade software name would be displayed in the upgrade list box.
Step 4: Select that software and then click upgrade button. It will upgrade automatically.
Note: Please wait for a while when the system reboots. Never cut off power during upgrading. The original configuration will be
reserved after upgrade.
6.4 Logoff
Enter into Menu Æ Logoff tab. A log off dialogue box will popup. The device will log off by clicking “OK” button. If you want to log
in again, click icon to enter into user name and password to re-login.