User manual

CCTV

4.2.2 Main Monitor

Step1: Enter into MenuÆSetupÆLiveÆMain Monitor tab. Refer to Fig 4-8:

Step2: Select split mode: 1×1、2×2、2×3、3×3、4×4 and channel. Click

button to setup the previous channel group. Click button to set the latter

channel group.

Step3: Set the dwell time.

Step5: Click “Default” to restore default setting; click “Apply” to save the setting;

click “Exit” to exit the current tab.

Fig 4-8 Main Monitor

4.2.3 Mask

You can setup private mask area (3 areas at most) on the live image picture.

Setup mask area: Click Setting button, enter into live image to press left mouse and drag mouse to set mask area. Please

refer to the below picture. Right click to exit. Click Apply button to save the setting.

Delete mask area: Select a certain mask area and double click to delete that mask area. Then click Apply button to save the

setting.

Fig 4-9 Mask Setup Mask Area Live Image Mask Area

4.3 Record Configuration

Record configuration includes six sub menus: enable, record bit rate, time, recycle record, stamp and snap.

4.3.1 Enable

Step1: Enter into MenuÆSetupÆRecordÆEnable tab. Refer to Fig 4-10:

Fig 4-10 Enable Record

Step2: Checkmark record and audio.

Step3: Select All to setup the same settings for all channels.

4.3.2 Record Bitrate

Step1: Enter into MenuÆSetupÆRecordÆRecord bit rate tab. Refer to Fig 4-11:

Step2: Setup rate, resolution and quality.

Step3: Select “All” to set same settings for all channels.

Step4: Click “Default” button to restore default setting; click “Apply” button to save the setting; click “Exit” button to exit the

current interface.

Note: If the rate value set is over high the maximum resources of the device, the value will be adjusted automatically.

Parameter Meaning

Record To enable/disable recording

for the channel

Audio To enable/disable audio

recording for the channel