User manual

65
EN
CCTV
3 Basic Function Instruction
3.1 Startup & Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper startup and shutdown are crucial
to expanding the life of your DVR.
3.1.1 Startup
Step1: Connect with the source power.
Step2: The device will boot and the power LED would turn blue.
Step3 A WIZZARD window will pop up and show some information about time zone，time setup，network configuration,
record configuration and disk management. User can setup here and refer to the concrete setup steps from the corresponding
chapters. If users don’t want to setup Wizard, please click Exit button to exit.
Press and hold Fn key to switch the output among VGA, HDMI and CVBS.
3.1.2 Shutdown
You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step1: Press Power button. This will bring up a shutdown window. The unit will shut down by clicking “OK” button.
Step2: Disconnect the power
By mouse:
Step1:Click Menu and select “Shut Down” icon. This will take you to a shutdown window.
Step2: Click OK. Then the unit will power off after a while.
Step3: Disconnect the power
3.2 Login
User can login or log off the DVR system. Once logged off the user cannot do any
other operation except changing the multi-screen display.
Notice: The default user name and password is “admin” and 123456”
For complete operational steps for changing password, adding or deleting users，
please refer to section 4.7 User Management Configuration.
Fig 3-1 Login
3.3 Live Preview
Fig 3-2 Live Preview Interface
Symbol Meaning
Green Manual record
Yellow Motion detection record
Blue Schedule record